Difference between revisions of "Post-production"

From Jeskola Buzz Wiki
Jump to: navigation, search
(Typical post-processing signal chain)
m (Typical post-processing signal chain)
 
Line 12: Line 12:
 
* Stereo width control
 
* Stereo width control
 
* Compressor
 
* Compressor
* Limiter or saturatior/clipper
+
* Limiter or saturation/clipping
  
 
[[Category:Production]]
 
[[Category:Production]]

Latest revision as of 19:02, 23 July 2009

Adding certain effects to the entire mix-down of your song can often spice up the over-all impression and make the mix "settle". There are two ways to do this when using Buzz:

  • Routing all audio to a series of effects instead of sending everything directly to the master output
  • Harddisk recording out a .wav file and processing this using various effects.

One choice is not better than the other. This is simply a matter of convenience depending on your workflow and your setup.

Many people use compressors, limiters and EQs to do post-processing, but be aware that if you send your music to a music publisher or record label, they will typically send their album to a mastering studio, who will then prefer to have your track without any post-processing done to it. On the other hand, post-processing is still a good idea when simply releasing a single track outside an album context.

Typical post-processing signal chain

  • Equalizer
  • Stereo width control
  • Compressor
  • Limiter or saturation/clipping